Seven strokes to repair furniture

When the furniture takes a long time, there will naturally be traces of bumps and bumps, and it will make people feel uncomfortable, but don't worry, here is the seven strokes of "Returning to Heaven", which will definitely change the "face" problem of your furniture. It is.

1 Refinish the paint surface If the furniture paint surface is burnt and damaged, you can put a fine cloth on the toothpick, gently wipe the traces, and then apply a thin layer of wax, the scorch marks can be removed; if the furniture paint rubs Injury, can be used in the same color as the furniture, crayons or pigments, wipe the wound on the furniture, cover the exposed background, and then apply a thin layer of transparent nail polish; if the wax drops on the furniture surface, thousand Do not use sharp edges or nails to scrape. Wait until the daytime light is good. Use plastic sheets, hold hands tightly, tilt forward, scrape the wax oil from the front of the body, and then wipe it with a fine cloth.

2 After the furniture surface is made up of the drum decorative veneer, you can use a sharp blade to cut a knife in the middle of the bubble in the direction of the wood grain, then use a syringe to inject the glue into the seam and gently press it on the upper part of the bubble with your finger. The spilled glue is cleaned with a damp cloth and pressed with a weight that is smooth on the bottom surface and larger than the bubble area. In order to prevent a small amount of glue from overflowing and sticking to the peripheral surface of the bubbling after the pressurization, the plastic film may be covered on the bubble so that the decorative veneer is flat.

3 Eliminate water marks on the furniture, if not immediately dry, will leave traces of water stains. In this case, the wet cloth can be used to cover the traces, and then the wet cloth is carefully pressed several times with an electric iron, and the trace moisture will evaporate with heat, and the water mark can be eliminated.

4 repairing dents Some furniture is soft due to wood and will leave dents after collision. At this time, you can use a wet towel to place it in the depression, and then iron it with an iron to restore it. If the dent is deep, add the filling.

5 Remove the old paint If you want to remove the paint from the furniture, you can remove the old paint by applying the failed developer to the paint surface of the furniture.

After washing and drying, it can be polished again with fine sandpaper.

6 repair cracked solid wood furniture, such as cracks due to heat expansion and contraction, the following remedies can be used; burn the old cotton cloth or broken sack into ash, and then mix with raw tung oil into a paste, embedded in the cracks of the wood, after drying Can be filled and stuck. Or, tear the newspaper into pieces. Add some alum and water, boil it into a thick paste, apply it to the cracks of the wood after cooling, and it is very firm after drying.

7 furniture rust chrome furniture is rusty, do not use sandpaper to polish. Small plating parts can be placed in a pot of organic oil for 8 to 10 hours, and rubbed with a cloth. The large plated furniture is rusted, and it can be applied to the rust with a brush or cotton gauze oil. After a while, wipe it with a cloth to remove the rust.